Maytag W10252706B Uživatelský manuál

INSTALLATION INSTRUCTIONS30" (76 CM) FREESTANDING ELECTRIC RANGESTable of ContentsRANGE SAFETY ...

10Direct Wire Installation: Copper or Aluminum WireThis range may be connected directly to the fuse disconnect or circuit breaker box. Depending on yo

116. Use ³⁄₈" nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10–32 hex nuts.7. Connect line 2 (

12Verify Anti-Tip Bracket Location1. On models with a storage drawer, remove storage drawer. See the “Storage Drawer” section.On models with a warming

13To Replace:1. Lift up the back of the storage drawer and place it inside the range in its fully forward position.2. Lift up the front of the storage

14Moving the RangeWhen moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering.If removing the range is necessary f

15ANTI-TIP BRACKET TEMPLATE Cut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall.Left edge

W10252706B© 2009.All rights reserved.9/09Printed in U.S.A.

2RANGE SAFETYYou can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don'tfollow All

3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w

4Product Dimensions*Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs.Cabinet DimensionsCabinet opening dimensions sho

5Electrical ConnectionTo properly install your range, you must determine the type of electrical connection you will be using and follow the instructio

6INSTALLATION INSTRUCTIONSUnpack Range1. Remove shipping materials, tape and film from range.2. Remove oven racks and parts package from inside oven.3

75. To mount anti-tip bracket to wood floor, drill two ¹⁄₈" (3.2 mm) holes at the positions marked on the bracket template. Remove template from

84. Add strain relief.Style 1: Power supply cord strain relief Remove the knockout for the power supply cord. Assemble a UL listed strain relief in

93. Feed the power supply cord through the strain relief on the cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring