
Before you start...
Check location where wall oven ALL OPENINGS IN THE WALL
WIII be Installed. The locatIon
OR FLOOR WHERE THE
Proper installation IS your responsibllit$
Make sure you have everything necessary
should be away from strong draft WALL OVEN IS TO BE INSTALLED
arem. such as windows, doors, MUST BE SEALED
for COrreCt installation. It IS the responsibility and strong heating vents or fans
of the Installer to comply with the instollatlon
The wall oven should be
clearance specified on the serloliratlng located for convenient use
Note Clearances specified
plate The serlalirailng plate can be
in the kitchen
are for combustible walls and
\e oven frame behlnd the
moterlals that hove o density of
found on tt
upper ovefl
FOR YOUR SAFETY
If you smell gas:
1. Open windows.
2. Don’t touch electrical switches
3. Extinguish any open flame.
4. Immediately call your gas
supplier.
wall gas line
opening - 71
max. len IrOn
~nlerolcabi”
35%” from
abInd bO”cw
I-----
---
0
I ’
I
I
I
I
I
I
I
I
I
I
t-----
‘\
\\-
\
24’ ‘\
cabinet
depth
are for wall oven sitiing 6n
adjacent to materlals that
cabinet floor. Cabinet floor must
are less than 20 pounds
be solid and level.
per cu fi or to plastic tiles
and sheeting
1 FOR YOUR SAFETY 1
Do not store or use gasoline
or other flammable vapors and
liquids in the vicinity of this
or any other appliance.
-
/I
B-
0
--
1
--‘---1
22’op%nl”g wldlh
1 FOR YOUR SAFETY 1
Do not obstruct the flow of
combustion and ventilation air.
1 FOR YOUR SAFETY 1
Important:
Observe
all governlng
codes ond ordlnonces. Fallure lo meet
codes and ordinances could lead to
fire or elecklcal shock hazard.
Mobile Home Installation
The installation of this range must
conform to the Manufactured Home
Construction and Safety Standards. Title
24 CFR. Port 32-80 [formerly the Federal
Standard for Moblle Home ConstructIon
and Safety. Title 24, HUD [part 28011.
Copies of the standards listed
may be obtalned from:
Back or oven
helghl-3,W
boltom
from floor
If ovens must hove outside
Grounded electrical outlet: IS required
See Electrical Requirements.
Proper gas supply connection must be The recesses rnstallatlon area must
available. See Gas Supply
pipe with 4” Inside
provide complete enclosure around the
diameter and 6” outside
Requirements.
recessed portion of the oven
diameter must be used
C
This wall oven is equipped for
n
use with NATURAL aas. It IS
‘American Gas Assoclallon
1515 Wllson Boulevard
Arflngton.Vlrglnlo 22209
“NatIonal Fire Prolectlon Assoclalion
Batterymarch Park
Qulncy, Massachusetts 02269
Tools needed for installation.
certified by A.G.A. for NATURAL and L.P
gases with appropriate conversion. The
seriol/ratlng plate located on the oven
frame behind the broiler door has
information on the type of gas that can
be used. If this information does not
agree with the type of gas available,
check with the local gas suppller See
Backcover for L.P gas conversIon
instructions.
D
n
Provide a gas supply line of
“8 rlcld pipe to the wall oven
location eltherthrd6gh the wall or
cabinet floor. Keep pipe near the wall.
The wall oven gas flttlng is located at
upper right side of appliance. Pipe joint
compounds resistant to the action of L.P
gas must be used With L.P gas. piplng or
tubing sfze can be ‘/2” minimum. L.P aas
suppliers usually determine the size&d
materials used on their system
Gas Supply
Requirements
G
n
pipe finin
in-line connectton to fhe wall oven. All
Observe all governing codes
and ordinances.
A
This instollatlon must conform
n
with local codes and
ordinances. In the absence of local
codes, installation must conform with
American National Standard, National
Fuel Gas Code ANSI 2223 l-1984’
strains must be removed from the supply
and fuel lines so wall oven will be level
and in line
H
The Inlet pressure to the
w regulator should be CIS follows
for both operation and checking
regulator senlng
E
If local codes permit, A.G A
n
cetiifled flexible metal tubing
(new] IS recommended for connecting
this wall oven to the gas supply IIne. Do
Not kink or damage the flexible tubing
when moving the wall oven AK” male
pipe thread IS needed for connectIon to
pressure regulator female pipe threads
NATURAL GAS:
Minimum pressure 5 inches
Maximum pressure 14 inches
L.P GAS;
Minimum pressure 11 inches
Maximum pressure 14 inches
I
The wall oven and its indlvlduol
n
shut-off valve must be
disconnected from the gas supply
plping system during any pressure
testing of that system at test pressures
in excess of K psig (3.5 kPo].
The wall oven must be isolated from the
gas supply piping system by closing Its
lndlvidual manual shut-off valve during
any pressure testing of the gas supply
piping system at test pressures equal to
or less than ‘/2 psig (3.5 kPa)
This valve should be located in the same
room OS the wall oven and should be in
a location that allows ease of opening
and closing. Do Not block access to
shut-off valve
This wall oven is equipped with an oven
burner shut-oft valve located on the wall
oven manifold.
serioliratlng plate are for
elevations up to 2,000 feet For
elevdtions above 2,000 feet, ratings
should be reduced at a rate of 4% for
each 1,000 feet above sea level.
PANEL A
Komentáře k této Příručce