
Move oven into cabinet
cutout and center, Check
that spacers behind front
frame are trght against
the front of the cabinet. Do
Not recess the spacers
The small gap provided
by spacers allows air flow
for cooling the cabinet.
If oven ~111 be vented outsrde. connect
the vent system. See backcover for
Venting Installation instructions
:;:,
10
Disconnect shut-off valve line
n
by removrng the flared nut
Remove two screws that attach the
manifold pipe and regulator to the
mountrng bracket Move regulator
skghtly and attach flexible conneciorio
pressure regulator Reconnect marxfold
pipe to mountrng bracket. Reconnect
shut-off valve.
11
n
Use pope jornt compound
resistant to the action of
L P gas to seal all gas connectIons If
flexible connectors are used, be certain
connectors are not krnked. Check that
the oven shut-off valve IS open
12
Open the shut-off valve rn the
n
gas supply line Wait a few
minutes for gas to move through the gas
line
13
Use a brush and liquid
n
detergent to test 011 gas
connectrons for leaks. Bubbles around
connectrons wrll Indicate a leak If a
leak appears, shut off gas valve controls
and adjust connections. Then check
connectrons agarn. NEVER TEST FOR GAS
LEAKS WITH A MATCH OR OTHER FLAME.
Clean all detergent solution from warI
oven.
or wall
oven
to
Rynnn,r+ \.,,r~
Push rn and turni,
’
the oven control knob to,
m
“300”F’The oven burner should light rn 50
to 60 seconds. This delay IS normal The
oven safety valve requires a certain time
before it will open and allow gas to flow.
17
No adjustment of the oven
H
burner is necessary. The hazy
appearance of the flame IS normal for
this type of burner.
ia
Replace oven door
.
by sliding the door over
hinge arms
( Congratulations! \
\
lnstru~llo~ and Guide close lo wall
1
oven for easy reference. The
InstructIons will make re-InstallIng
your WhIrlpool wall we” In
another home as easy as
the tlrst Installation.
PANEL C
Komentáře k této Příručce